Resources · November 2026
Operating guide for the first week
Setup, gas, wire, and how to change a preset without chasing five variables at once.
The English quick-start in the crate is the document for the machine you bought. This page is the sequence a shop can rehearse before the crate arrives. Parameter numbers live on the sheet for that controller. They are not universal across every air-cooled cabinet in this class.
Before power
- Set the cabinet so the air path is clear. Do not push the back panel against a wall.
- Confirm the supply matches the quote. Do not adapt 110 V with a domestic plug strip.
- Connect process gas. Stainless usually runs on nitrogen. Aluminum runs on argon. The bottle and the regulator are the buyer’s.
- Clamp the ground to the work, not to a painted stand.
- Thread the wire that matches the base metal. Close the feeder on the size named for that liner.
- Put on eyewear rated for the wavelength on the machine label, and keep other people out of the beam path.
First beads
Call the preset closest to your material and thickness. Change one thing at a time: travel speed, wire speed, or wobble width. If the bead is tall and cold, you are travelling too fast or feeding too much wire. If the edge burns back, you are slow or hot. Write down the preset name when the bead is acceptable. That note is more useful than a photo of the screen taken at an angle.
Fit-up
Handheld laser likes contact. A butt joint with a visible gap is a different weld. Close the gap, or switch to a lap, or use a wobble width that the preset allows. Do not compensate for a 2 mm gap by turning the power to the end of the scale and hoping.
Daily care
- Check the protective window. A spattered window is the usual reason a gun “gets weak”.
- Keep grinding dust out of the cabinet vents.
- Replace nozzles when they are oval or packed with spatter.
- Stop if the interlock, the ground detect, or a temperature alarm says stop. Do not bridge a safety circuit.